Wednesday, 31 May 2017

Fouga pushrods and Flanker nose

Not too much here, as I am progressing quickly with the Fox and failing to take photo's of it!  Then again, it's practically an ARTF.

Some issues when flying the Fouga at the last PSSA event were caused by floppy pushrods, which I have since remedied with 5mm carbon shafts and M3 hardware either end :


 These now cross over in the fuselage, so I will have some re-programming to do next time I hit the slopes :

And lastly, the Flanker nose is now ready for primer.  5 or 6 coats of hard floor varnish on top of the glass, and we're good to go :


No comments:

Post a Comment