Tuesday, 20 June 2017

1/6th Scale PSS A10 Thunderbolt II - upgrades and repairs - part 2

Some progress on the new A10 tail.  Once two sheets of 3/32nd  have been joined, I can start drawing out servo positions (brought over from the old elevators) and a general rib layout :


Dry fit of ribs, hard 1/4" balsa TE glued on :


Ribs start going on over lower square sub-spar, after having been run-through with the large brass tube for lightening holes :


All ribs in, as well as new 12mm OD carbon tube spar, and upper square sub-spar :


Onwards!

No comments:

Post a Comment